Dual Light Indicator; Fan - Vulcan-Hart V SERIES Service Manual

V SERIES FOOD HOLDING, TRANSPORT, AND BANQUET CARTS
5. Replace knob and tighten set
screws.
6. Reconnect the cabinet to its
power source and test.

DUAL LIGHT INDICATOR

1. Remove the cover.
2. Refer to the wiring diagram to
identify the electrical leads that
connect to the indicator light.
3. Disconnect the wire leads to the
indicator light.
4. Depress the
retaining clips on the indicator
light housing and remove the
light from the front of the control
panel.
5. Install the replacement indicator
light by pushing it into the control
panel opening and the retaining
clips snap into place.
6. Complete the
reversing the above steps.
7. Reconnect the cabinet to its
power source and test.
side mounted
installation by
11

FAN

VHFA9, VHFA18
1. Remove the five (5) screws from
the fan mounting plate. (Fig. 10)
2. Unplug the fan power cord.
(Fig. 17)
FAN POWER CORD
Fig. 17
3. Remove the four (4) fan attaching
screws and remove fan. (Fig. 10)
4. Install the replacement fan and
complete the
reversing the above steps.
5. Reconnect the cabinet to its
power source and test.
F-41141 (11-09)
CONNECTOR
installation by