Component Removal And Replacement; Cover Removal; Thermometer - Vulcan-Hart V SERIES Service Manual

V SERIES FOOD HOLDING, TRANSPORT, AND BANQUET CARTS

COMPONENT REMOVAL AND REPLACEMENT

COVER REMOVAL

The Cover must be removed to access
the Thermostat, Thermometer, Lights,
and Wiring.
1. Locate and remove the two (2)
screws holding the top cover to
the left side.
2. Locate and remove the two (2)
screws holding the top cover to
the right side.
3. Locate and remove the two (2)
screws holding the top cover to
the back.
4. Remove the cover.
(Reverse the above steps to install.)

THERMOMETER

1. Remove the Cover.
2. Identify and remove the screw
that holds
sensing bulb on the inside of the
cabinet. It will be mounted to the
top of the cabinet. (Fig. 13)
the thermometer
9
SCREWS
Fig. 13
4. Pull the thermometer
through the access hole located
in the top of the cabinet.
5. Remove the retaining nuts that
hold the thermometer to the
housing located on the back of
the control panel. (Fig. 14)
THERMOMETER
RETAINING NUTS
Fig. 14
6. Remove the
pushing it from the rear through
the control panel.
7. Install the
thermometer by reversing the
above steps.
8. Reconnect the cabinet to its
power source and test.
F-41141 (11-09)
ACCESS HOLE
bulb
thermometer by
replacement