Fan; Elements (Vhfa9, Vhfa18); Probe; Lockout / Tagout Procedure - Vulcan-Hart V SERIES Service Manual

V SERIES FOOD HOLDING, TRANSPORT, AND BANQUET CARTS
MODELS: VHFA9, VHFA18 (continued)

FAN

The fan is located on top of the unit. The
fan and air tunnel provide even heat
distribution. The fan is turned on and off
with the POWER ON/OFF SWITCH.
ELEMENTS
There are 2 heating elements located at the
bottom of the cabinet.
WARNING
PROCEDURE before removing any sheet metal panels or
attempting to service this equipment.
FAILURE TO COMPLY WITH THIS PROCEDURE CAN CAUSE
PROPERTY DAMAGE, INJURY OR DEATH.
The Lockout / Tagout Procedure is used to protect personnel working on an electrical
appliance. Before performing any type of maintenance or service on an electrically
operated appliance, follow these steps:
1. In electrical box, place unit's circuit breaker into OFF position.
2. Place a lock or other device on electrical box cover to prevent someone from
placing circuit breaker ON.
3. Place a tag on electrical box cover to indicate that unit has been disconnected for
service and power should not be restored until tag is removed by maintenance
personnel.
4. Disconnect unit power cord from electrical outlet.
5. Place a tag on cord to indicate that oven has been disconnected for service and
power should not be restored until tag is removed by maintenance personnel.

LOCKOUT / TAGOUT PROCEDURE

Always perform the LOCKOUT / TAGOUT
8

PROBE

THERMOSTAT: Monitors/sensors
output temperature of the heating elements.
Once the output temperature of the heating
element reaches the set temperature, the
thermostat sensor removes power from the
heating element.
THERMOMETER: Senses the temperature
in the cabinet.
F-41141 (11-09)
the