Continuous paper does not feed properly
Regular gaps occur in the printout.
Cause
Skip-over-perforation may be
on.
The perforation is not aligned with the tear-off position.
Cause
The tear-off position is not
properly set.
The auto tear-off setting may
be turned on in the default-
setting mode.
The page length setting for
continuous paper is not
correct in the default-setting
mode.
The tractor does not feed the paper.
Cause
The paper-release lever may
be set to the wrong position.
The paper has come off the
tractor feeder.
10-20
Troubleshooting
What to do
Set skip-over-perforation to off in the
default-setting mode. See "Using the
Default-Setting Mode" in Chapter 8.
What to do
Adjust the tear-off position using a
Micro Adjust button. To use the
micro-adjust feature, see "Adjusting
the tear-off position" in Chapter 7.
Turn this setting off. See "Using the
Default- Setting Mode" in Chapter 8.
Change the setting using the
default-setting mode. See "Using the
Default-Setting Mode" in Chapter 8.
What to do
Move the paper-release lever to the
continuous-paper position.
Reattach the paper to the tractor.