Epson Stylus 1520 User Manual page 128

4. Move the center support to a point midway between the edge
guides.
5. Pull out the output tray extension as far as it will go.
6. Gently extend the rear edge guide of the paper support until
it stops.
7. Fan a stack of paper; then tap it on a flat surface to even the
edges.
8. Load the stack of paper, printable side down, so that the right
edge of the stack is against the right side of the sheet feeder.
Next, slide the left edge guide against the left edge of the
paper.
7-4
Paper Handling