Replacing Ink Cartridges - Epson Stylus Photo RX700 Series Basic Operation Manual

Replacing Ink Cartridges

Note:
Before replacing an ink cartridge, read "Precautions on
Ink Cartridge Replacement" on page 39 and "When
handling ink cartridges" on page 3.
1. When the ink is empty:
Refer to the LCD panel message to see which ink
cartridge is empty.
When the ink is low:
Proceed to the next step.
2. Open the cartridge covers.
3. Remove an ink cartridge from its package.
4. Gently push in on the ink cartridge that you
want to replace. Pull the cartridge out of this
product and dispose of it properly. Do not take
the used cartridge apart or try to refill it.
The illustration shows replacement of the light
cyan ink cartridge.
Warning:
w
If ink gets on your hands, wash them
thoroughly with soap and water. If ink gets
into your eyes, flush them immediately with
water. If discomfort or vision problems
continue after a thorough flushing, see a
doctor immediately.
Caution:
c
Leave the used ink cartridge installed until
just before replacement; otherwise, ink
remaining in the print head nozzles may dry
out.
40
Replacing Ink Cartridges
5. Insert the new ink cartridge slowly until it clicks
into place.
6. Close the cartridge covers.
Caution:
c
Never turn off this product while ink charging
in progress; Otherwise, this will cause
incomplete charging of the ink.
Note:
❏ Do not repeatedly remove and reinsert the ink
cartridge once it is installed.
❏ If you install a used ink cartridge with a low ink
level, it may become empty right after the
replacement. In this case, replace the ink
cartridge with a new one.