Using The Default Setting Mode - Epson PRO Reference Manual

Alt/Cleaning Used in combination with other buttons to reset the
Using special button combinations
The functions listed below are available when you hold down a
combination of buttons when turning on the printer.
Self test (Operate + Load/Eject)
Checks the paper length and performs a self test by printing
fonts and colors. Hold down the Load/Eject button and then
press the Operate button for several seconds until the printer
advances a sheet of paper. See "Testing the Printer" in
Chapter 1 of the Setup and Software Guide. To stop the self test,
press Pause and then turn off the printer.
Hex dump (Operate + Font + Load/Eject)
On a PC, prints data in hexadecimal code for troubleshooting
analysis. See the Troubleshooting section in Chapter 3.
Default setting mode (Operate + Economy/Condensed)
Enters the Default setting mode. See "Using the Default Setting
Mode" on page 2-6 for more information.
Note:
To exit the hex dump or Default setting mode, press the Pause
button and then the Operate button to turn off the printer.
Reset printer (Alt + Pause)
Clears the printer's buffer and resets the printer settings to
their factory defaults. Hold down both buttons for about 5
seconds.
printer, clean the print heads, or adjust the paper
thickness lever. See "Cleaning the Print Heads" in
Chapter 3 and "Loading Envelopes and Heavy
Paper" in Chapter 1 for more information.
Controlling the Printer
2-5