IRiver iHP-100 Series Instruction Manual page 17

Push the MENU/NAVI handle toward
the remote control toward BITRATE to select BITRATE TYPE to set
recording quality. This is only for MP3 file.
When saving as WAV file, the Bitrate is 1411Kbps.
(44.1 KHz, 16Bit, Stereo)
Push the REC button to start recording.
When recording from an external audio device, be sure to start the
playback on that device when recording on to the iHP-100 Series.
NOTE Volume level can not be controlled on the iHP-100 Series while
recording from an external device.
While recording, press (STOP/PWR OFF) to stop recording and
switch to recording standby mode. Press the REC button again to
begin recording to a new file.
30
or or push the REC button on
,
To pause recording
Press REC button to pause recording, press
REC button again to start recording.
To stop recording
At recording standby mode, press and hold
mode.
Recorded files are stored in folders matching the source name from
where the audio was recorded.
- Line In : ROOT\RECORD\AUDIO\AUDIOXXX.MP3(WAV)
- Mic In : ROOT\RECORD\VOICE\VOICEXXX.MP3(WAV)
Recording is automatically stopped if:
- The iHP-100 Series's memory is full.
- When the recorded MP3 file size is over 195MB
- When the recorded WAV file size is over 795MB
- The recorded time is longer than 5 hours.
- The battery is low.
To play the recorded file
Press button to play the recorded file at the
recording standby mode.
button to go previous
31