Epson Photo 700 User Manual page 119

Troubleshooting
Paper doesn't eject fully or is wrinkled
Possible cause
If the paper doesn't eject
fully, you may have set the
wrong paper size.
If it's wrinkled when it
comes out, the paper may
be damp or too thin.
Paper doesn't feed
Try this
Remove the stack of paper
from the sheet feeder.
Paper jams inside the printer
Try this
Turn off your printer, open
the cover, and remove all
the paper that's inside,
including any small pieces
that may have torn off.
Solution
Press the E load/eject button to eject the paper. Then make sure
you select the correct paper size in your application or printer
software. (See the paper specifications on page B-2 for the paper
sizes you can print with.)
See the paper specifications on page B-2 for paper thicknesses
you can print with, as well as environmental requirements for
storage.
Then do this
Check that the paper:
Isn't curled or creased.
Isn't too old (see page 3-3 or your paper packaging for more
information).
Isn't loaded above the arrow on the left edge guide.
Isn't jammed inside the printer. (If the S paper out light is
flashing, paper is jammed.)
Then reload the paper as described on page 3-2, making sure the
left edge guide is adjusted to fit the paper's width.
Then do this
Reload the paper as described in the Getting Started guide and
Chapter 3. If your paper jams frequently, make sure you:
Use smooth, high-quality paper, loaded printable side up.
Fan the stack and then even the edges before loading it.
Don't load paper above the arrow mark on the left edge guide.
Adjust the left edge guide to fit the width of your paper.
6-16