Mounting The New Volumes; Verifying Client Operations - HP StorageWorks P9000 Configuration Manual

5. Specify the Virtual Server Name, IP Address, Advertising Protocols and, if necessary, the CIFS
Server Name.
6. Select Create.

Mounting the new volumes

NetWare 5.x
1. From the Available Disk Options screen, click NetWare Volume options to display the volume
list and volume options, and then click Mount/Dismount an existing volume and press Enter.
2. On the Directory Services Login/Authentication screen, enter the NetWare administrator
password, then press Enter.
3. An informational message displays the number of new volumes just added. Press Enter to
continue.
4. You are now prompted to select the desired mount action. Click either Mount all volumes or
Mount volumes selectively as desired.
The mount status for all volumes is now displayed.
5. If you chose to mount volumes selectively, select the desired volume, press Enter to mount the
volume, and then confirm that the volume's status changed to MOUNTED. Repeat this step
for each new volume to confirm that all new volumes can be mounted successfully.
6. When you have confirmed that all new volumes/devices were mounted successfully, you are
finished with disk array device configuration. Leave the new volumes mounted for now, so
you can verify that NetWare clients can access the new volumes.
NetWare 6.0
1. Using ConsoleOne, right-click the targeted server, and click Properties.
2. Click the Media tab, and click NSS Logical Volumes.
3. Click New, enter a name for the volume, then click Next.
4. In the Create Logical Volume - Storage Information window, select the desired pool/device,
enter the desired Volume Quota, then click Next.
5. In the Create Logical Volume - Storage Information window check Activate and Mount in the
"On Creation" box, then click Finish.
6. Confirm that the logical volume has been created.
7. Map the created Logical Volume as the Network Drive.
8. Confirm the mapped drive.
NetWare 6.5
1. Enter NSSMU at the server console.
2. In the main menu, select Volumes.
3. Press Insert and enter a name for the new volume, then click Next.
4. Select the desired pool/device, enter the desired Volume Quota, then click Next.
5. Review and change volume attributes as necessary.
6. Select Create.

Verifying client operations

After configuring the Novell NetWare system, verify that NetWare clients can access the new
volumes. To verify access:
1. Copy an existing file onto each new volume.
2. Verify that the file was copied successfully.
Configuring disk devices 43