Setting And Verifying The Auto-Mount Parameters - HP StorageWorks P9000 Configuration Manual

/ldev/vg00/lvol1
:
/ldev/vg06/lvol1
4. As a final verification, perform some basic UNIX operations (for example file creation, copying,
and deletion) on each logical device to make sure that the devices on the disk array are fully
operational.
Example
#cd /AHPMD-LU00
#cp /bin/vi /AHPMD-LU00/vi.back1
#ls -l
drwxr-xr-t 2 root root 8192 Mar 15 11:35 lost+found
-rwxr-xr-x 1 root sys 217088 Mar 15 11:41 vi.back1
#cp vi.back1 vi.back2
#ls -l drwxr-xr-t 2 root root 8192 Mar 15 11:35 lost+found
-rwxr-xr-x 1 root sys 217088 Mar 15 11:41 vi.back1
-rwxr-xr-x 1 root sys 217088 Mar 15 11:52 vi.back2

Setting and verifying the auto-mount parameters

Set up and verify the auto-mount parameters for each new volume. The /etc/checklist file
(which can also be called the /etc/fstab file) contains the auto-mount parameters for the logical
volumes.
To set up and verify the auto-mount parameters:
1. Edit the /etc/checklist (/etc/fstab) file to add a line for each OPEN-x device on the
disk array. This example and the following table show the auto-mount parameters.
Example
#cp -ip /etc/checklist /etc/checklist.standard
#vi /etc/checklist
/dev/vg00/lvol1
/dev/vg00/lvol2
:
/dev/vg06/lvol1
/dev/vg06/lvol2
P1
Table 6 Auto-mount parameters (HP-UX)
Parameter
P1
P2
P3
P4
P5
P6
P7
2. Reboot the system.
28 HP-UX
59797 59364
2348177 9
/
swap
/AHPMD-LU00
/AHPMD-LU01
P2
Name
Device to mount
Mount point
File system
Mount options
Enhance
File system check (fsck pass)
Comments
0 100%
2113350 0%
hfs rw 0
ignore rw 0
hfs defaults 0
hfs defaults 0
P3 P4 P5 P6
Enter
Block-type device file name
Mount directory name
Type of file system (for example, hfs, vxfs)
"defaults" or other appropriate mount options
0
Order for performing file system checks
Comment statement
/
/AHPMD-LU00
1 # root
0 # primary swap
2 # AHPMD-LU00
2 # AHPMD-LU01
P7