Creating The Mount Directories; Mounting And Verifying The File Systems - HP StorageWorks P9000 Configuration Manual

Example
# pvchange -t 60 /dev/dsk/c0t6d0
Physical volume "/dev/dsk/c0t6d0" has been successfully changed.
Volume Group configuration for /dev/vg06 has been saved in
/etc/lvmconf/vg06.conf.
3. Verify that the new I/O timeout value is 60 seconds using the pvdisplay command:
Example
# pvdisplay /dev/dsk/c0t6d0
--- Physical volumes ---
PV Name
VG Name
PV Status
:
Stale PE
IO Timeout (Seconds)
4. Repeat steps 1–3 for each new disk connected to the system.

Creating the mount directories

Create a mount directory for each logical volume. Choose a unique name for each mount directory
that identifies the logical volume.
To create a mount directory for each logical volume:
1. Use mkdir with the new mount directory name as the argument to create the mount directory.
Example
# mkdir /AHPMD-LU00
2. Use the ls
Example
The following example shows the root directory as the location for the mount directories.
# ls -x
AHPMD-LU00
floppy
3. Repeat steps 1–2 for each logical volume on the disk array.

Mounting and verifying the file systems

After the mount directories have been created, mount and verify the file system for each logical
volume.
To mount and verify the file systems:
1. Use mount to mount the file system for the volume.
Example
# mount /dev/vg06/lvol1
2. Repeat step 1 for each logical volume on the disk array.
If you need to unmount a file system, use the unmount command.
3. Use the bdf command to verify that the file systems are correct. The capacity is listed under
Kbytes.
Example
# bdf
Filesystem
/dev/dsk/c0t6d0
/dev/vg06
available
0
60 [New I/O timeout value]
x command to verify the new mount directory.
bin dev
home hstsboof
/AHPMD-LU00
Kbytes used
device etc
kadb kernel
avail %used Mounted on
Configuring disk array devices
export
lib
27