Solve Setup Problems - Lexmark X443 User Manual

If your problem is not in the
table, see the documentation
that shipped with your printer.

Solve setup problems

Problem
is not displayed on the
Ready
control panel display.
A copy of my test document did
not print.
The control panel does not respond
to any button presses.
I can't move to next selection when
setting time and date.
The scan unit isn't working.
I am unable to send or receive
faxes.
→ →
Scan Profile, Scan e-mail, and/or
→
doesn't appear in the
Scan FTP
control panel as modes
.
Solution
The control panel and the printer are not
talking to each other, or the printer may be
turned off.
•
Turn printer off, and then back on.
•
Turn printer and scan unit off. Check that
everything is correctly connected, and
then power up in the correct order. First
turn on the scan unit, and then the printer.
•
Verify each electrical outlet has power.
•
Make sure all cables and line cords are
properly seated.
Make sure the printer is turned on.
Press Copy Size to move to the next selection,
or Original Size to go back. Press Return when
completed.
Turn printer and scan unit off. Check that
everything is correctly connected, and then
power up in the correct order. First turn on the
scan unit, and then the printer.
•
Check hardware setup. Make sure the
telephone fax line cable is properly
connected to the fax modem port on the
MarkNet N2501e and to the fax phone
wall outlet.
•
The required information may not be set
correctly. Repeat the fax setup. See "Set
required fax information" on page 20.
•
For more troubleshooting information
about sending or receiving faxes, see
"Solve fax problems" on page 50.
Scan to network modes must be configured in
order to show up in the OptraImage control
panel.
See "Configure scan to network functions" on
page 23.
31