Lexmark X443 User Manual page 105

18
Slide the other end of the new pick roller 1 into the upper hole of the right
holding bracket. Make sure the gears on the pick roller is seated well with
the gears of the ADF.
19
Carefully move and turn each bearing until it fits back inside the bracket
hole. The bearings are shaped to fit the holes precisely.
20
When both bearings are back in the bracket holes, slide the retaining sleeve
back toward the left holding bracket until it snaps into a groove on the pick
roller. If done correctly, the pick roller is fixed in place.
21
Reattach the guide.
22
Insert and tighten the thumbscrews.
23
Close the ADF.
97