Using The Xc 340 As A Room Monitor - Uniden XC 340 Operating Manual

Transferring
a Call
from the Handset
Using the XC 340 as a Room Monitor
You may use the XC 340 Handset to monitor activity near the Base Unit without
anyone present at the Base Unit.
To turn Room Monitoring on:
1. Remove the Handset from the Base Unit.
2. Press INT'COM on the Handset.
3. Press TALK on the Handset. Two-way communications are now set up
between the Base Unit and the Handset.
NOTE: Press VOLUME/R. VOL on the Handset to adjust the earpiece
volumes to loud or soft.
To turn mon~oring off, press TALK at the Handset.
23
BASE UNIT HANDSET
Press INT'C. (If no answer, press INT'C
again to disconnect.)
Press SPEAKER or INrCOM, and answer
the page. The IN USE LED flashes.
Announce there is a call waiting.
Press TALK to transfer call.
Talk to caller. (To transfer call back to
Handset, see "Transferring
a Call from
the Base Unit"
on previous page.)
Press TALK to enable 3-way conversation
Press SPEAKER to disconnect.
Press TALK to disconnect.