Using The Exp 9100 As A Room Monitor - Uniden EXP 9100 Instructions Manual

Paging the Base Unit While a Call is Holding
1. Press INT'COM on the Handset. If no answer, press TALK or INT'COM to
disconnect and return to the call ON HOLD.
2. At the Base Unit, press INT'COM to answer the page. Speak into the
microphone.
3. To turn off the Intercom press INT'COM at the Base Unit
— OR —
Press TALK on the Handset. The Handset returns to the call ON HOLD.
Paging from the Handset to the Base Unit
1. Press INT'COM. on the Handset (If no answer, press INT'COM again to
disconnect.)
2. At the Base Unit, press INT'COM to answer the page. Speak into the
microphone.
3. To turn off the Intercom, press INT'COM at the Base Unit
— OR —
Press TALK or INT'COM on the Handset.

Using the EXP 9100 as a Room Monitor

You may use the EXP 9100 Handset to monitor activity near the Base Unit
without anyone present at the Base Unit.
To turn Room Monitoring on:
1. Remove the Handset from the Base Unit.
2. Press INT'COM on the Handset.
3. Press TALK on the Handset. Two-way communications are now set up
between the Base Unit and the Handset.
NOTE: Press VOL/RVOL on the Handset to adjust the earpiece volume to
loud or soft.
4. To change to one-way communication (Handset to Base only) for private
listening, press MONITOR on the Handset.
NOTE: Press VOL/RVOL on the Handset to adjust the Monitor Speaker
volume to loud or soft.
To turn monitoring off, press TALK at the Handset.
19