Using Your Xc 340; Selecting Pulse Or Tone Dialing; Setting The Handset Ringer Tone; Setting The Handset Ringer Volume - Uniden XC 340 Operating Manual

Using Your XC 340
Selecting Pulse or Tone Dialing
(Available on Australian Models only)
Australian models can use either Pulse Dialing or Tone Dialing, depending on the.
local service. New Zealand models are Tone Dialing only.
To set the phone for Tone or Pulse Dialing, place the TONE/PULSE switch on
the Base Unit in the proper position.
Setting the Handset Ringer Tone
Press
the FLASH/R. TONE button on the Handset to select either of two ringer
tones.
(Note:
This sets the ringer tones only when the phone is not in use.)
Setting the Handset Ringer Volume
Press the VOLUME/R. VOL button on the Handset to select either high or Iow ringer
volume.
(Note: This
sets the ringer volume only when the phone is not in use.)
Setting
the Base
Unit Ringer Volume
To enable the Base Unit to ring when a call or page is received, set the BASE
UNIT RINGER switch to either "LO" or "HI".
(Note: When a callis ON HOLD
at the Handset and the Base Unit is paged, the Base Unit willring even when
the BASE UN" RINGER switch is set in the "OFF" position.)
16