Table of Contents
Advertisement
Troubleshooting
If your XC 340 Cordless Telephone is not performing to your expectations,
please try these simple steps. Ifyou are still unable to resolve the problems,
contact Uniden Customer Service for assistance.
24
Problem
Suggestion
Charge light does not come on when
.
Make sure the AC Adaptor is plugged
Handset is placed on Base Unit.
into the Base Unit and wall outlet.
.
Make sure the Handset is properly
seated in Base Unit.
.
Make sure the Nickel-Cadmium
Battery
Pack is plugged in inside the Handset.
.
Make sure that the charge contacts on
the Handset and Base Unit are clean.
(See page 15, for instructions)
Audio sounds weak and/or scratchy.
.
Make sure that the Base Unit antenna
is fully extended and vertical.
.
Move the Handset and/or Base Unit to
different locations and try again.
.
Press the CHANNEL button to select
another channel.
Can't make or receive calls.
.
Move the Handset closer to the Base.
.
Check both ends of the Base Unit
telephone line cord.
.
Make sure the AC Adaptor is plugged
into the Base Unit and wall outlet.
.
Disconnect the AC Adaptor for a few
minutes, and then reconnect it.
Handset can't ring or receive a page.
.
Nickel-Cadmium
Battery Pack may be
weak. Charge the battery on the Base
Unit for more than 12 hours.
.
Set the RING ON/BA TT SAVE switch
on the Handset to "RING ON".
. Extend the Base Unit antenna vertically.
.
The Handset may be too far away from
the Base Unit.
.
Place the Base Unit away from noise
sources.
.
The Digital Security Code may be
erased. Set the Digital Code.
(See page 5 for instructions.)
Base Unit can't ring or receive a page.
.
Set the BASE UNIT RINGER switch to
"LO" or "HI".
Advertisement
Table of Contents
