TYAN Thunder n3600QX User Manual page 69

Feature
Memory Configuration
Memclock Mode
Memory Clock Value
MCT Timing Mode
CAS Latency (CL)
TRAS
TRP
TRCD
TRRD
TRC
Bank Interleaving
Enable Clock to All DIMMs
MemClk Tristate
C3/ATLVID
CS Spuring Enable
DQS Signal Training
Control
Memory Hole Remapping
Option
Select the DRAM Frequency
Limit
programming method. If Auto, the
DRAM speed will be based on
Auto SPDs. If Limit, the DRAM speed will
not exceed the specified value. If
Manual, the DRAM speed specified
Manual
will be programmed by users.
400
533
Set Memory Value
667
800
Manual Allow user to configure the MCT
Timing Mode manually.
Auto
Auto
Set CAS Latency
3.0 ~ 6.0
Auto
Set TRAS
5CLK ~ 18CLK
Auto
Set TRP
3CLK ~ 6CLK
Auto
Set TRCD
3CLK ~ 6CLK
Auto
Set TRRD
2T ~ 5T
Auto
Set TRC
11T ~ 25T
Disabled
Enable Bank Memory Interleaving
Auto
Enable unused clocks to DIMMs
Enabled
even memory slots are not
Disabled
populated.
Enabled Enable/Disable MemClk Tri-Stating
during C3 and Alt VID
Disabled
Reserve a spare memory rank in
Enabled
each mode.
Disabled
Turning this off will require custom
Enabled
memory timings programming.
Training will be automatically
Disabled
disabled if CS sparing is enabled.
Enabled Enable Memory Remapping around
Memory Hole
Disabled
69
Description