Envelope Loading; Using The Cut Sheet Feeder - Epson FX-1050 User Manual

Envelope loading

Envelopes are loaded in much the same way as regular paper. To load
envelopes, you need to do the following:
1. Set the paper thickness lever to match the thickness of your
envelopes. (For specific information on paper thickness settings, see
the section on printing with special paper in Chapter 2.)
2. Follow steps 1 through 5 of the previous section on paper loading to
load envelopes. You can load up to 25 plain or bond envelopes, or 30
air mail envelopes.
3. Push down on the two front levers until they lock into position.

Using the cut sheet feeder

After loading paper into the cut sheet feeder, make sure the ON LINE light
is on. Once the printer is in the sheet feeder mode, a new sheet of paper
loads automatically whenever a printable character or line feed
command is sent to the printer.
When the cut sheet feeder runs out of paper, it stops paper feeding and
the PAPER OUT light comes on. To start printing again, load more paper
7-8
Using Printer Options