Table 5 Language Table Id's - TransAct Epic 880 100-88002 Integration Manual

print. To allow other code pages to be created by an application, a redefine character
set command is provided.
As discussed above, there are two commands for language selection in IBM mode.
The first is [ESC] !, which selects one of 19 international character sets. The [ESC] !
command does not allow all of the possible character sets to be selected, it is
provided for compatibility with older programs only. The second is [ESC] [ T, which
selects any of the 58 code pages. In EPOS mode, the [ESC] R command has been
expanded to select any of the 59 international character sets or code pages.
[ESC] ! Select international character set (Legacy Command)
ASCII [ESC] ! <n>
Hexadecimal 1BH 21H <n>
Decimal <27> <33> <n>
IPCL &%CS <n>
EPOS [ESC] R <n>
Description The [ESC] ! <n> command selects international character set <n>. In
standard mode, the value of <n> is as follows.
Note: This command is supported in ASCII mode only.
<n> Language
64-'@' ASCII (slashed zero)
65-'A' ASCII (unslashed zero)
66-'B' British
67-'C' German
68-'D' French
69-'E' Swedish
70-'F' Danish
71-'G' Norwegian
72-'H' Dutch
[ESC] [ T Select character code page
ASCII [ESC] [ T <n
Hexadecimal 1BH 5BH 54H <n
Decimal <27> <91> <84> <n
IPCL &%CP <m > <m
1
EPOS [ESC] t <n>
Description The [ESC] [ T <n
TM
<n >. The Epic 880 Printer supports many code pages. The following code pages
l
are supported.
Note: This command is supported in ASCII mode only.
Note: See Appendix E: Internal Code Page Definitions for the internally
defined code pages. Additional code pages may be defined and loaded as
Codepage definition files.
<n>
73-'I'
74-'J'
75-'K'
76-'L'
77 –'M'
78-'N'
79-'O'
80-'P'
81-'Q'

Table 5 Language Table ID's

> <n >
h l
> <n >
h l
> <n >
h l
> <m > <m >
2 3 4
> <n > command selects character code page <n
h l
100-88002 Rev B
Control Codes
Language
Italian
French Canadian
Spanish
Swedish II
Swedish III
Swedish IV
Turkish
Swiss I
Swiss II
Page 97
>
h