Sony KDP-57XBR2 Operating Instructions Manual page 75

Other Information
Programming the Remote Control
0oo®
l s°s v_S
The remote control is preset to operate Sony brand video equipment.
Sony Switch Position Programmable
Equipment on Remote Control Code Number
Beta, ED Beta VCRs AV1 303
8 mm VCR AV2 302
MS VCR AV3 301
DVD Player DVD 751
If you have video equipment other than Sony brand that you want to
control with the projection TV's remote control, use the following
procedures to program the remote control.
The equipment must have infrared (IR) remote capability in order to be used
with the remote control.
I
2
3
Check the list of the "Manufacturer's Codes" listed on page 70,
and find the three-digit code number for the manufacturer for
your equipment. (If more than one code number is listed, start
with the number listed first.)
Open the panel on the remote control. Then move the slide
switch to one of the four positions (AV1, AV2, AV3, DVD).
Press CODE SET.
Z:_ You must perform step 4 within I 0 secondsof step 3.
4
5
6
Close the panel on the remote control and enter the three-digit
manufacturer's code number.
Press ENTER,
To check if the code number works, aim the projection TV's
remote control at the equipment and press the green POWER
button that corresponds with that equipment. If it responds, you
are done. If not, try using another code listed for that
manufacturer.
68