Sony KDP-57XBR2 Operating Instructions Manual page 3

Safety
[1 Operate the projection TV only on 120 V AC.
[1 The plug is designed, for safety purposes, to fit into the wall
outlet only one way. If you are unable to insert the plug fully
into the outlet, contact your dealer.
VI If any liquid or solid object should fall inside the cabinet,
unplug the projection TV immediately and have it checked
by qualified service personnel before operating it further.
71 If you will not be using the projection TV for several days,
disconnect the power by pulling the plug liselL Never pull on
the cord.
[7 For details concerning safety precautions, see "Important
Safeguards."
Installing
To prevent internal heat buildup, do not block the ventilation
openings.
Do not install the projection TV in a hot or humid place, or in
a place subject to excessive dust or mechanical vibration.
D Avoid operating the projection TV at temperature below 5°C
(41°F).
VI If the projection TV is transported dii_ctly from a cold to a
warm location, or if the room temperature changes suddenly,
the picture may be blurred or show poor color. In this case,
please wait a few hours to let the moisture evaporate before
turning on the projection TV.
FI To obtain the best picture, do not expose the screen to direct
illumination or direct sunlight. It is recommended to use spot
lighting directed down from the ceiling or to cover the
windows that face the screen with opaque drapery. It is
desirable to install the projection TV in a room where the
floor and walls are not of a reflective material.
I_ As an ENERGYSTAR®Partner,
Sony has determined that this
product or product models meets
the ENERGYSTAR ®guidelines
for energy efficiency.
ENERGY STAR _ is a U.S. registered mark.
Trademark Information
DO [DOLBY ] Manufacfured underlicensefromDolby
Laboratories Licensing Corporation.
D I (I I T A L Dolby
and the double-D
symbol are
trademarks of Dolby Laboratories
Licensing Corporation.
XBR is a registered trademark and CineMotion is a trademark of
Sony.
i.LINK is a h'ademark of Sony used only to designate that a
product contains an IEEE 1394 connector. All products with an
i.LINK connector may not communicate with each other.
Owner's Record
The model and serial numbers are located at the rear of the
projection TV, below the Sony logo, on the sticker, and also on the
TV box (white label). Record these numbers in the spaces provided
below. Refer to them whenever you call upon your Sony dealer
regarding this product.
Model No.
SerialNo.