6: Selectingthe Speaker System - Sony STR-DG510 Operating Instructions Manual

Insert two R6 (size-AA) batteries in the
RM-AAU013 remote commander.
Observe the correct polarity when installing
batteries.
Notes
• Do not leave the remote in an extremely hot or
humid place.
• Do not use a new battery with old ones.
• Do not mix alkaline batteries and other kinds of
batteries.
• Do not expose the remote sensor to direct sunlight
or lighting apparatuses. Doing so may cause a
malfunction.
• If you do not intend to use the remote lor an
extended period of time. remove the batteries to
avoid possible damage from battery leakage and
corrosion.
• When you replace the batteries, the remote buttons
may be reset to their factory settings. If this
happens, reassign the buttons again (page 61).
Tip
Under normal conditions, the batteries should last
1or about 3 mouths. When the rmnote no longer
operates the receiver, replace all the batteries with
uew oues.
6: Selectingthe speaker
system
You can select the front speakers you want to
drive.
Be sure to use the buttons on the receiver for
this operation.
SPEAKERS (OFF/A/B)
Press SPEAKERS (OFF/A/B)
repeatedly to select the front
speaker system you want to drive.
To select Light up
The speakers connected to the SPA
SPEAKERS FRONT A terminals
The speakers connected to the SP B
SPEAKERS FRONT B terminals
To turn off the speaker output, press
SPEAKERS (OFF/A/B) repeatedly until the
"SPA" and "SP B" indicators on the display
do not light up.
Note
You cannot switch the lbout speaker system by
pressing SPEAKERS (OFF/A/B) when the
headphones are connected to the receiver.
if)
O
I'D
D.
27G8