Preparing The Receiver; Initializing The Receiver; Selecting The Speaker System - Sony STR-DH710 Operating Instructions Manual

Preparing the Receiver

Initializing the receiver

Before using the receiver for the first time,
initialize the receiver by performing the
following procedure. This procedure can also
be used to return settings you have made to
their initial settings.
Be sure to use the buttons on the receiver for
this operation.
?/1
?/1
TONE INPUT SELECTOR
SPEAKERS
MEMORY/
TONE MODE INPUT MODE TUNING MODE TUNING ENTER
PHONES
1
Press ?/1 to turn off the
receiver.
2
Hold down ?/1 for 5 seconds.
After "CLEARING" appears on the
display for a while, "CLEARED"
appears.
All the settings you have changed or
adjusted are reset to the initial settings.
MASTER VOLUME
2CH/
A.DIRECT A.F.D. MOVIE MUSIC DISPLAY DIMMER MUTING
VIDEO 2 IN
AUTO CAL MIC VIDEO L AUDIO R
Selecting the speaker
system
You can select the front speakers you want to
drive.
Be sure to use the buttons on the receiver for
this operation.
SPEAKERS
?/1
Press SPEAKERS repeatedly to
select the front speaker system
you want to drive.
To select the front speakers
connected to
The SPEAKERS FRONT A
terminals
The SPEAKERS SURROUND
BACK/FRONT HIGH/BI-AMP/
FRONT B terminals
Both the SPEAKERS FRONT A and
SPEAKERS SURROUND BACK/
FRONT HIGH/BI-AMP/FRONT B
terminals (parallel connection)
* To select "SPK B" or "SPK A+B", set
"SB ASGN" to "SPK B" in the SPEAKER menu
(page 79).
To turn off the speaker output
Press SPEAKERS repeatedly until "SPK
OFF" appears on the display.
Note
This setting is not available when the headphones
are connected.
Display
SPK A
SPK B*
SPK A+B*
33 GB