Specifications - Sony STR-DG510 Operating Instructions Manual

PROTECT
Irregular current is output from the
speakers. The receiver will automatically
turn off after a few seconds. Check the
speaker connection and turn on the power
again.
If you are unable to remedy the
problem using the
troubleshooting guide
Clearing tile receiver's memory may remedy
the proNem (page 26). However, note that all
memorized settings will be reset to their
factory settings and you will have to readjust
all settings on the receiver.
If the problem persist
Consult your nearest Sony dealer. Note that if
service personnel changes some parts during
repair, these parts may be retained.
Reference sections for clearing
the receiver's memory
To clear See
All men/orized settings page 26
Customized sound fields page 52
Specifications
AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
(Models of area code U only)
With 8 ohm loads, both channels dri_,en, from
20 20,000 Hz; rated 90 watts per channel
mininmm RMS power, with no more than
0.09% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
Models of area code U, CA ])
Mininmm RMS Output Power (8 ohms, 20 Hz -
20 kHz, THD 0.09r7_ )
90 W + 90 W
Stereo Mode Output Power (8 ohms, 1 kHz,
THD P/_)
100 W + 100 W
Surround Mode Output Power 2) (8 ohms, 1 kHz,
THD 10%)
130 W/ch
Models ol area code CEL, CEK, AU, TW l)
Mininmm RMS Oulpul Power (8 ohms, 20 Hz -
20 kHz, THD 0.09r7_ ) 1_.
85W+85W "
Sleren Mode Outpul Power (8 ohms, 1 kHz,
THD 1%) -_
100 W + 100 W m_.
Surround Mode Ontpul Power 2) (8 ohrns, 1 kHz,
THD l ()r/_)
130 W/ch
Models ol area code SP, E2 l)
Minimum RMS Oulpnl Power (8 ohms, 20 Hz -
20 kHz, THD 0.09r/_ )
70 W + 70 W
Sleren Mode Oulpul Power (8 ohms, 1 kHz,
THD 1%)
80 W + 80 W
Surround Mode Outpul Power 2) (8 ohms, 1 kHz,
THD 10r7_)
120 W/ch
continued_
67G8