Sony Handycam DCR-SR100 Operating Manual page 17

E"
;D The CHG (charge) lamp turns off
when the battery is fully charged.
Remove the AC Adaptor from the
DC IN jack on your camcorder.
• Remove the AC Adaptor holding bolh your
cmncorder
mM lhe DC plug.
To removethe battery pack
Slide tile POWER switch to OFF (CH(;).
Slide tile BATT (battery) release lever and
remove the battery pack.
• When yoll relllO_,'ethe battery pack, nlake sure
that none ol the respective lamps ol the POWER
switch (p.I 9) is on.
Whenstoring thebattery pack
Use up the battery pack c'omplelely if you do
not intend to use it for a long lime (p.95).
Touseanoutside powersource
Make the same connections as you do when
charging the battery pack. The battery pack
will not lose its charge in this case.
Chargingtime(fullcharge)
Approxilnale lime (rain.) required when you
fully charge a fully' discharged battery pack.
NP-FP50
125
NP-FP60 (supplied) 135
NP-FP70
155
NP-FP71 170
NP-FPg0 220
Recordingtime
Approxilnate lilne (rain.) available when you
use a fully' charged battery pack.
60 30
NP-FP50 65 30
65 30
95 45
NP-FP60
100 50
Isupplied) 105 50
130 65
NP-FP70
140 70
145 70
155 75
NP-FP71 170 85
175 85
235 115
NP-FP90 255 125
260 130
* Typical recording time shows tile time when you
repeal recording starl/_qop, turning lhe power (711/
oll and zooming.
• Times shown vary according to the lollowing
conditions.
Top: When file LCD backligla lurns on,
Middle: When lhe LCD backlight lurns o11.
Bottom: Recording time when recording with
the viewfinder while the LCD panel is closed.
Continued =_
17