Sony CMT-DV2D Operating Instructions Manual page 40

Should you encounter a problem with your
system, do the l;.)llowing:
1
Make sure the power cord and speaker
cords are correctly and firmly connected.
2 Find your problem in the troubleshooting
checklist below and take the indicated
corrective action,
If the problem persists after doing all of the
above, consult your nearest Sony dealer.
When the I/_ indicator flashes
hnmediately unplug the power cord and
check the lollowing items.
• If your system has a voltage selector, is the
voltage selector set to the correct voltage?
Check the voltage l\>r your region, then
make sure the voltage selector is set
correctly.
• Are the + and - speaker cords short-
circuited?
• Are you using the supplied speakers?
• ls anything blocking the ventilation holes
on the rear of the system?
Check all tire above items and fix any
problems fotmd. Afler I/(_) indicator stops
flashing, reconnect the power cord and turn
on tire system. If the indicator still flashes, or
if the cause of the problem cannot be t_mnd
even after checking all the above items,
consult your nearest Sony dealer.
General
''i i:i i'' appears in the display.
• A power interruption has occurred. Set the clock
(page I 1) and timer settings (pages 32 and 33)
again.
The clock setting/radio presetting/timer is
canceled.
• Redo the follo,,;ing:
"Setting the clock" (page 11 )
"Presetting radio stations" (page 25)
"Falling asleep to music" and "Waking up to
music" (page 32)
"Timer recording radio programs" (page 33)
There is no sound.
• Press VOLUME +.
• Make sure the headphones are not connected.
• Check the speaker connections (page 8)
• There is no audio output during Rec Timer
• The system is in pause mode or in slowmotion
play mode Press DVD _ (or DVD D,,41 on the
unit) to return to Normal Play
• Set "Dolby Digital" or DTS" under "AV" to
"PCM"
There is severe hum or noise.
• Mo_e II_e system a_ay from tlw source of noise.
• Connect the system to a different wall outlet.
• lnqdl a noise filter (commercially available) to
the power cord.
The timer cannot be set.
• Set the clock again (page 11)
The timer does not function
• Check the timer setting and set the correct time
(pages 32 and 33)
• Cancel the Sleep Timer fimction (page 32)
The remote does not function.
• Remove the obstacle
• Move the remote closer to Ihe system
• Point the remote at the system's sensor
• Replace the batteries (R6/size AA)
• Locate the system away from Ihe fluorescent light
There is acoustic feedback.
• Reduce the volume
• Move the microphone away from the speakers or
change the direction of the microphone (CMT
SV2D Asian and Oceanian models only)
40 GB