Sony CMT-DV2D Operating Instructions Manual page 37

To enhance your system, you can connect optional components. Refer to 1he operating instructions
provided with each component. Norlh American model is used for illustralion l_urposc.
TV or VCR, etc,
From the audio output jack
of the connected
component
[ Amplifier or MD deck
1 To the digital input jack of
the digital component
n,
i ........
i li:ii!ii
i!(?,
ii
[] DIGITAL OUT (OPTICAL) jack
Use a digital optical cord (square, not supplied)
to connect an amplifier, MD deck or DAT deck
with a digital optical input jack. Sound is then
output when the system function is set to DVD.
By connecting this system to the optical input
jack of the optional amplifier equipped with
Dolby Digital or DTS decoder, you can enjoy
the 5.1 channel sound.
lu addition, when the CD or DVD audio is linear
PCM, you can make a digital recording from this
system to an MD deck or DAT deck.
Notes
• When playing a VIDEO CD er MP3 audio tracks,
you cannot output digital audio.
• You can recerd digital audio from this system enly
when DVD functien is selected.
• Yeu cannot make a digital rccoMing ef a cepy
guardeddisc using a digital component connected te
this system. Also, playback may net be pessible
depending on the connected component.
• DVD linear PCM output is output at a sampling
frequency of 48 kHz regardless of the disc being
played back.
• When you connect a component that does net support
Delby Digital or DTS to the DIGITAL OUT
(OPTICAL).jack and output a Dolby Digital or DTS
bit stream, noise may be heard frem the connected
component.
[] TV IN L/R jacks
Use audio cords (not supplied) to connect an
optional analog component (TV or VCR, etc.) to
these jacks. You can then record or listen to from
the component through this system.
O
O
O
3
o
37 GB