Connecting the Printer to Your Computer
For the laser printer to be able to receive and interpret information
from your computer, both devices need to be set up so that they can
communicate correctly. This requires having
cable and selecting
select from
the
Parallel
l
RS-232C serial
l
RS-422A serial.
l
Choosing an interface
When connecting the laser printer to your computer, you first have
to determine whether a parallel or serial connection should be used.
Many computers only provide one type of connection for a printer.
If both serial and parallel connections are available, it is normally
better to use
the
port of your computer free for devices such as modems. If you are ii
any doubt about which type of connection to make,
computer dealer.
Your printer is set up at the factory for parallel communication. If
your computer also uses parallel communication, you should be
able to connect up immediately, provided you have a shielded
parallel interface cable.
If, however, you find
change the communications settings with SelecType as described in
Chapter 3. You also need to find out which type of serial interface is
required by your computer (RS-232C or RS-422A) and set the
printer's DIP switches accordingly. (The DIP switches are factory set
for the RS-232C serial interface.)
right communications settings. You
the
following built-in interfaces:
parallel interface for the printer, leaving the serial
you need a serial interface, you must
that
Testing and Connecting Your Printer
interface
the correct
can
your
consult
2-11