Exit Selectype And Reset The Printer - Epson Action Laser Action Laser User Manual

7. Press the
SET
blinking, and
8. Use the
9. Press the
SET
indicating that the
blinking and the function starts blinking.
10. To exit
the
use the
message I/F
If you wish to exit SelecType at this point, see the section below
exiting SelecType.

Exit SelecType and reset the printer

To exit SelecType
implement your changes, follow these steps:
1. When you
button. The printer is set off line.
2. Hold down the
the message RESET
options are implemented in the printer's
change them
Note: To implement
and interface submenu settings you must also turn the
LOAD,
printer off. Remember to leave the printer off for at least five
seconds before turning it back on.
button to activate the option. The function stops
option starts blinking.
the
o r button to move to
button. An asterisk (*) appears next to the option,
option has been set. The option stops
new
emulation submenu and return to the main menu,
or button to take you back to
= SERIAL* appears in the display.
any main menu or submenu function) and
(from
set all the options you want, press the SelecType
have
CONTINUE/RESET
appears) to implement your changes. The
or initialize them to the factory
changes to the DATA BUFFER, OVER
option you want to set.
the
main menu. The
the
button for three seconds (until
memory
settings.
Using the Printer
Using SelecType
on
until you
3-17