Brother DreamWeaver„ XE VM6200D Operation Manual page 52

UPPER THREADING
h
Guide the thread down, up, then down
through the groove, as shown in the
illustration.
Memo
• Look in the upper groove area to check if
the thread catches on the take-up lever
visible inside the upper groove area.
a Look in the upper groove area
i
Pass the thread through the needle bar
thread guide (marked "6") by holding the
thread with both hands and guiding it as
shown in the illustration.
a Needle bar thread guide
j
Press the "Presser Foot Lifter" button to
lower presser foot.
B-50
k
Pass the thread through the thread guide
disks (marked "7"). Make sure that the
thread passes through the groove in the
thread guide.
a Groove in thread guide
l
Pull the thread up through the thread cutter
to cut the thread, as shown in the
illustration.
a Thread cutter
Note
• When using thread that quickly winds off
the spool, such as metallic thread, it may be
difficult to thread the needle if the thread is
cut.
Therefore, instead of using the thread
cutter, pull out about 80 mm (approx. 3
inches) of thread after passing it through the
thread guide disks (marked "7").
a 80 mm (approx. 3 inches) or more