Using The Foot Controller - Brother DreamWeaver„ XE VM6200D Operation Manual

SEWING
g
Press the "Start/Stop" button to start
sewing.
* Guide the fabric lightly by hand.
Memo
• When the foot controller is being used, you
cannot start sewing by pressing the
"Start/Stop" button.
h
Press the "Start/Stop" button again to stop
sewing.
i
Press the "Thread Cutter" button to trim
the upper and lower threads.
→ The needle will return to the up position
automatically.
CAUTION
• Do not press the "Thread Cutter" button after
the threads have been cut. Doing so could
tangle the thread or break the needle and
damage the machine.
• Do not press the "Thread Cutter" button when
there is no fabric set in the machine or during
machine operation. The thread may tangle,
possibly resulting in damage.
S-4
Note
• When cutting thread thicker than #30, nylon
monofilament thread, or other decorative
threads, use the thread cutter on the side of
the machine.
j
When the needle has stopped moving, raise
the presser foot and remove the fabric.
Memo
• This machine is equipped with a bobbin
thread sensor that warns you when the
bobbin thread is almost empty. When the
bobbin thread is nearly empty, the machine
automatically stops. However, if the
"Start/Stop" button is pressed, a few
stitches can be sewn. When the warning
displays, re-thread the machine
immediately.

■ Using the Foot Controller

You can also use the foot controller to start and stop
sewing.
CAUTION
• Do not allow fabric pieces and dust to collect
in the foot controller. Doing so could cause a
fire or an electric shock.
Memo
• When the foot controller is being used, you
cannot start sewing by pressing the
"Start/Stop" button.
(For embroidery and sewing machine only)
• The foot controller cannot be used when
embroidering.
• The foot controller can be used for sewing
utility and decorative stitches when the
embroidery unit is attached.