Accessories:
G
J
G:
Allen wrench (1)
H:
Bolts (4)
I:
Bolts (2)
J:
Collars (2)
K:
Phillips screws with washers (4)
L:
Wing screws (2)
M:
Washers (2)
2. Insert one of the legs into the base as shown. (The bolt holes line up only
if the leg is matched with the correct base.) Use the included Allen
wrench to fasten the leg with two bolts (H).
H
1-19
Setting Up the Printer
H
K
L
for attaching legs to base
for attaching lower bar to legs
for attaching lower bar to legs
for attaching top support bar to legs
for attaching printer to stand
for attaching printer to stand
Bolt holes
Underside view of base
showing location of bolt holes
|
19
I
M