Caution
Using an improperly
shielded USB cable—
especially a cable more
than 6.6 ft. (2 meters)
long—may cause the
printer to malfunction.
Windows System Requirements
To use your printer in either a standalone or peer-to-peer network
environment, your system should include the requirements listed below:
®
IBM
-compatible PC with a Pentium
•
recommended
For parallel connection: Windows
•
For USB connection: PC with USB-compliant port running Windows
98 (factory installed), Me, 2000, or XP
For IEEE 1394 connection: PC with IEEE 1394 port running
Windows Me, 2000, or XP
For 10/100 BaseT Ethernet connection: Ethernet equipped PC running
Windows 95, 98, Me, NT 4.0, 2000, or XP
256MB of RAM or higher recommended
•
At least 25MB of free hard disk space to install the software, and at least
•
2GB of free hard disk space for processing files (8GB or more available
hard disk space recommended)
Quad-speed (4×) CD-ROM or DVD drive for installing the printer
•
software
For parallel connection: a high-speed, bidirectional, IEEE 1284-
•
compliant parallel cable, 6 to 10 ft. (1.8 to 3 m) long, with a D-SUB,
25-pin, male connector for your computer and a 36-pin, Centronics
compatible connector for the printer
For USB connection: a computer running Windows 98, Me, 2000, or
XP with a Windows compliant USB port and a shielded USB "AB"
cable from Series A (computer) to Series B (printer), up to 6.6 ft.
(2 meters) long
For IEEE 1394 connection: the optional IEEE 1394 port (described on
page 10) and a shielded IEEE 1394 cable
For network connection: the optional Ethernet card (described on
page 10) and a compatible cable
®
®
95, 98, Me, NT
13
Introduction
IV 1 GHz or higher processor
®
4.0, 2000, or XP
|
13
®