Configuring Parameters for Sampling with Multiple Sensors
Use the [Multiple] tab to configure parameters for simultaneous sampling with multiple
sensors. The [Multiple] tab lets you select up to three channels for sampling, from among the
EA-200's CH1, CH2, CH3, and SONIC channels.
u To configure parameters for sampling with multiple sensors
(1) Start up the E-Con EA-200 application.
• This displays the [Single] tab of the Sensor Setup window.
• If the E-Con EA-200 application is already running and another window (besides the
Sensor Setup window) is displayed, tap C to change to the Sensor Setup window.
(2) Tap the [Multiple] tab.
• This displays the [Multiple] tab, which appears as
shown to the right.
(3) Tap inside the box of one of the sensors you want to
select ([CH1], [CH2], [CH3], [SONIC]).
• This causes a Select Sensor dialog box like the one
shown to the right to appear. The dialog box shown
here is for CH1, CH2, and CH3.
Basic Steps for Configuring Sampling Parameters
20031201
2-7