Saving Sample Data - Casio E-Con EA-200 User Manual

Saving Sample Data

The data produced by an EA-200 sampling operation controlled from the E-Con EA-200
application is stored temporarily in the ClassPad's [EConSamp] folder. This temporary data
is called the "current data".
• Current data is saved using one or more variables, one for each of the channels that was
used for sampling. Variable names are assigned automatically in accordance with the
channel and sensor used for sampling.
Variable Name
CH1
CH2
CH3
SONIC
MIC
FFT
Performing a sampling operation when [CASIO] - [Microphone] is selected on the Sensor
Setup window and the [FFT Graph] setting is turned on simultaneously creates two sets of
current data with variable names "MIC" and "FFT".
• The current data is displayed on the [Current] tab of the E-Con Graph Editor window in the
format <variable name>.
5-5
Executing a Sampling Operation
Channel and Sensor Used for Sampling
CH1
CH2
CH3
SONIC
EA-200's built-in microphone
Current data is saved under this variable whenever either of the
following sensor settings is selected.
• [CASIO] - [Microphone]
• [CASIO] - [Speaker (Sample Data)]
EA-200's built-in microphone
Current data is saved under this variable whenever either of the
following sensor settings is selected.
• [CASIO] - [Microphone-FFT]
• [CASIO] - [Microphone], with the [FFT Graph] setting turned on
• [Vernier] - [Microphone], with the [FFT Graph] setting turned on
Sample Display
20031201