Appendix B. Hp Emulation Mode; Hp Emulation Mode Vs Hp Laserjet Iii; Printable Area - Epson 60 Operator's Manual

APPENDIX B. HP EMULATION MODE

This section informs you about using your printer's HP emulation mode. It describes
the unique features of your printer's HP emulation as well as the differences between
your printer's HP emulation and printing with an actual HP LaserJet printer.

HP EMULATION MODE VS HP LASERJET III

Your printer differs slightly from a HP LaserJet III because the two printers use different
technologies. The differences in printing are explained below.
Input paper supply
Paper size
Resident fonts
Maximum no. of fonts per page
Page buffer mode

Printable Area

The size of the printable area for the HP LaserJet se -
ries III and this printer is the same. The maximum
number of characters per line is also the same. How -
ever, the position of the printout on the page may not
be exactly the same as for output from a HP Laser -
Jet series III.
If you wish to match your printing to the output pro -
duced on a HP LaserJet series III printer, use the T-
OFFSET and L-OFFSET controls (see page 30) to
make fine adjustments to the printing start position.
However, the offset controls can move the data out -
side the printable area, so some data may be miss -
ing.
The printable areas for various paper sizes are
shown in the following table.
Paper Size
A4
Letter
Legal
Units: Dots at 300 dpi
B-1
Your Printer
Refer to the specifications for
the base fax machine.
Bitmap: 14
Scalable: 13
Depends on the amount of memory
Built-in
l x
2380
50
2450
2450
HP LaserJet Series III
200 sheets
Letter, Legal, A4, Executive,
Monarch 7-3/4
Commercial 10, DL, C5
Bitmap: 10
Scalable: 8
Not available
r t
3407
50 50
3200
4100
Portrait
Paper
feed
y b
50