Ch Timeout (Channel Timeout) - Epson 60 Operator's Manual

ADJUSTING THE PRINTER SETTINGS
Allocate the required memory proportion to
the S channel. The value can only be from 0
to 9. Press
Then press
Do the same for the P channel.
Ignore the O channel. Just press
Then either:
Press to cancel the new setting.
Then go back to step 3 or press
return to printer "Ready" mode.
Press to store the new setting.
The machine resets itself and returns to
printer "Ready" mode.

CH TIMEOUT (Channel Timeout)

This allows you to set the time for a channel timeout. If the printer is on line and re -
ceives no new data for the number of seconds specified, and if there is data in the
other channel, the printer will automatically switch to the other channel. The factory set -
ting is 60 seconds.
Available Options: 10 to 600 seconds (in steps of 10).
1. Enter Level 2 mode (see page 34).
2. Press or
3. To change the current setting:
4. Press or
played.
5. Store the displayed setting:
6. twice to return to printer "Ready" mode.
40
or until the setting is correct.
.
until CH TIMEOUT is displayed.
until the required setting is dis -
.
twice to