Ch (Channel) - Epson 60 Operator's Manual

ADJUSTING THE PRINTER SETTINGS
2. Press or
played.
3.
Note: CH P indicates that the setting on the screen is for the parallel channel. If
you wish to adjust the serial channel, now press
CH S. Ignore CH O.
4.
5. Press or
played.
6. Store the displayed setting:
7. Either:
Press to cancel the new setting.
Go to step 4, or press
turn to printer standby mode.
Press to store the new setting.
The printer resets itself and returns to
printer "Ready" mode.

CH (Channel)

If you are only using one computer with the printer, you can ignore this section. If you
are using two computers, read this section carefully before deciding what settings to
use.
The CH feature gives you the choice of two settings to specify how the printer's mem -
ory is allocated to each channel. The CH setting has no effect on fax memory.
AUTOSENSE: The printer automatically detects which channel (parallel or serial) is
receiving data, and allocates all the available printer memory to that channel.
INDIVIDUAL: You allocate a separate portion of the available memory for each
channel.
AUTOSENSE is less complicated and requires less total memory. However, there is a
small chance that files sent from two different computers at exactly the same time will
interfere with each other. The INDIVIDUAL mode eliminates this possibility.
There are two ways to set up Autosense mode: AUTOSENSE P and AUTOSENSE S.
38
until RX-BUFFER SIZE is dis -
until the required setting is dis -
three times to re -
or until you see