General Information; Document History - Texas Instruments Chipcon Products CC2420 Manual

2.4 ghz ieee 802.15.4 / zigbee-ready rf transceiver
Hide thumbs Also See for Chipcon Products CC2420:
Table of Contents

Advertisement

42 General Information

42.1 Document History

Revision
Date
SWRS041b
2007-03-19
SWRS041a
2006-12-18
SWRS041
2006-04-06
(1.4)
1.3
2005-10-03
Description/Changes
Slightly changed optimum load impedance on Page 9 and 19 to better describe the
Application circuit.
Updated ordering information.
Updated address information.
Typical data latency changed from 2 to 3 us.
Updates reflecting the programmable polarity of FIFO, FIFOP, SFD and CCA pins.
Clarification relating to VREG_EN as digital input.
BATT_OK changed to BATTMON_OK for consistency.
MANFIDH.VERSION register, reset value changed to "current version is 3".
Added reset values for several registers.
Some typographical changes.
Removed Chipcon specific Disclaimer, Trademarks and Life Support Policy sections.
Ordering part number changed from CC2420-RTB2 and CC2420-RTR2 to CC2420Z-
RTB1 and CC2420Z-RTR1 respectively.
Important: New recommended setting for RXBPF_LOCUR in RXCTRL1 (0x17) use 1
instead of reset value 0.
Updated address information.
Added new balun circuit with transmission lines in section Application Circuit.
Updated electrical specifications with measured data on CC2420 EM with new balun.
Updated values and figure for suggested application circuit with folded dipole
antenna.
Corrected values for capacitors in Table 2, discrete balun.
Added data latency figure in receiver specification.
Updated crystal oscillator start up time.
Updated PLL loop filter bandwidth.
Updated adjacent channel rejection figures.
Updated current consumption for RX mode.
Typographical errors corrected in text and figures.
Removed comment about tuning capacitor for crystal oscillator.
Added statement that RAM access shall not be used for FIFO access.
Added more details about RSSI.
Clarified the interpretation of a programmed synchronisation word.
Updated purchasing information.
Updated soldering standard.
Added chapter numbering and split table for electrical specifications for readability.
Gathered and added information related to pin configurations in section 13.
Included TX_UNDERFLOW and RX_UNDERFLOW in state diagram.
Disclaimer updated to include Z-stack
Product status changed to "Full Production".
SWRS041B
TM
information.
CC2420
Page 86 of 89

Advertisement

Table of Contents
loading

Table of Contents