Table of Contents
Advertisement
Test-Um NT955 Series
Validator
TM
Uploading/Downloading Jobs
7.2. Downloading Test Results from Validator-NT to Plan-Um
Open the My Computer folder on your desktop. Power the Validator-
NT on. Plug the USB cord into the USB port on your PC and into the
Validator-NT (Figure 7.1). As the connection is made, the drive the
Validator is mapped to (usually Local Disk E:) appears on your desktop
and the message "USB – File I/O Mode" appears in red on the Validator.
Right click the drive the Validator is connected to and select Copy. Open
the My Documents folder on your desktop, right click, and select Paste.
Select Yes to replace the previous file with one you just downloaded that
contains the test results.
Do not remove the USB cable after this procedure; instead follow
the instructions below to safely remove the USB cable. On your
system tray (lower right side on your desk top), click the USB icon to
safely remove hardware or Stop Mass Storage Device.
Open Plan-Um and open the selected job file to view the populated
Length and Results columns of the Cable Test Schedule.
Figure 7.1 Diagram of Validator-NT Connected to PC
92
Hide quick links:
Advertisement
Table of Contents
