Battery Info - Test-Um Validator-NT NT955 Operating Instructions Manual

Test-Um NT955 Series

2.1. Battery Info

This screen indicates whether the unit is operating on Battery Power or
External Power and displays information that allows the user to monitor
the remaining charge status and aging of the battery.
(Figure 2.2 & Figure 2.3)
Charge Remaining: Displays the percentage of charge
remaining in percentages ranging from 0% to 100%. As the
battery discharges, the percentage of remaining charge is
reported in 10% steps.
Status: Reports the status of the charge cycle as Charging,
Normal (temperature in range), Charge Cycle Complete,
Automatic Shutdown Pending, Temperature Out of Range (too
high or too low to charge), Cannot Read Battery Status, or No
Battery.
Serial Number: Allows the user to identify a specific battery
Charge Cycles: Reports the number of times the battery
charger completes the charge cycle.
Remaining Maximum Capacity: An estimate of the ability of
the battery to store the charge.
Total Charge Accumulated: Tracks the amount of charge put
into the battery.
The Battery Info screen also includes a Reset Charge (RST CHRG) F1
soft key. The purpose of this function is to reset the charge cycle when
you change out the battery. You can also start a new charge cycle by
disconnecting the AC adapter momentarily.
The battery from the remote can be placed into the main unit and its
properties can be viewed.
Note: For additional power and battery information see the Battery
and Power Management section of this guide.
37
Validator Validator TM TM Properties Properties