Calibrate - Test-Um Validator-NT NT955 Operating Instructions Manual

Test-Um NT955 Series

1.6. Calibrate

The calibration procedure is performed to set a reference point for cable
length to 0 feet/meters. Once calibration is performed, the test unit
retains the information. The Validator-NT does not require any other
calibration. (Figure 1.7)
Calibrate
Untitled1.job
Note: Please disconnect all Patch Cables
100%
To calibrate the unit make sure there are no
cables plugged into the unit. (Unless a patch
cord is being used)
Figure 1.7 Calibrating The Unit
Validator Validator TM TM
2005 Aug 25 Test-Um Inc.
10:53:01
validator
Continue
35
Setting Up the Test Tool Setting Up the Test Tool