Test-Um Validator-NT NT955 Operating Instructions Manual page 58

Test-Um NT955 Series
Auto Find Feature: It is necessary to connect the Validator-NT remote
unit to the other end of the cable to measure for both Speed and
Performance. If the remote is not plugged in a message will appear
"Remote not found. Alternating between Tone and Test." We call this
"Auto Find" and it is a feature that let's you start the test and then go to
the other end where the remote should be plugged in. If the end of the
cable being tested is not known Validator-NT helps by generating tone
on the line so that a tone probe can be used to locate the far end of the
cable. Auto Find will terminate when the remote is plugged in.
Test Results
100%
Untitled1.job
Length
Max: 300ft
A Split
188ft
B
C Split
186ft
D
BERT Results:
BACKSPC PG UP PG DOWN
Figure 4.6 Test Results-Split
Test Results
100%
Untitled1.job
Cable001
REMOTE NOT FOUND
Alternating Tone and Test.
Figure 4.7 Cable Test without Remote
Validator
Test-Um Inc.
2005 Aug 25
10:53:01
validator
Skew SNR
Max: 35ns Min:20db
-- --
-- --
-- --
-- --
Test-Um Inc.
2005 Aug 25
10:53:01
validator
57
TM How AutoTest Works