Test-Um Validator-NT NT955 Operating Instructions Manual page 87

Test-Um NT955 Series
4. To clear the current broadcast, press the Clear soft key (F1).
The screen goes blank.
CDP Display Screen
Untitled1.job
BACKSPC
5. To start a new broadcast, press the Start soft key (F2). The
message "Reading CDP packets from network" appears on your
screen below the CDP message.
6. To stop the current broadcast, press the Stop soft key (F3). A
message "Ignoring CDP packets from network" appears on the
screen below the CDP message.
100%
Reading CDP packets from network.
CLEAR START
6.16 Selecting Clear for CDP Display Screen
CDP Display Screen
100%
Untitled1.job
Port (Our Port): eth0
Device-ID: cisco_3524
Device addresses:
IP address: 192.168.1.252
Holdtime: 179 sec
Capabilities: Transparent_Bridge Switch
Version:
Cisco Internetwork Operating System Software
IOS ™ C3500XL Software (C3500XL-C3H2S-M),
Version 12.05(5)XU, RELEASE SOFTWARE (fc1)
Copyright (c) 1986-3000 by cisco Systems Inc.
Ignoring CDP packets from network.
BACKSPC CLEAR START
6.17 Selecting Stop for CDP Display Screen
Test-Um Inc.
2006 Jul 05
10:53:01
validator
STOP
Test-Um Inc.
2006 Jul 05
10:53:01
validator
SAVE TYPE
86