Wand Emulation
For external power operation:
Plug the 9-pin connector at the end of the scanner's coil cord into one
•
end of the battery box.
Use the appropriate output cable from the battery box to connect the
•
LS 3603 to the host device.
Connect one end of this cable to the battery box and the other to the
•
appropriate port on the host device.
Plug the power supply connector into the receptacle on the side of the
•
battery box. Connect the power supply plug into an AC outlet.
For direct host power operation:
Plug the scanner directly into the scanner input port of the host device.
For battery operation:
Insert a 9-volt battery into the battery box. See the Battery Box
•
Operation section on
Plug the scanner's 9-pin connector at the end of the coil cord into one end
•
of the battery box.
An output cable from the battery box connects the LS 3603 to the host
•
device. Connect one end of this cable to the battery box and the other to
the appropriate port on the host device.
page
1-10.
User's Guide
1-5