Stamina 55-1537C Owner's Manual page 7

ASSEMBLY INSTRUCTIONS
STEP 3
Slide the bottom of the two
(92).
Align the desired hole on the arm with the peg on the bracket, then insert the peg into the hole to lock
PIVOT ARMS(91)
the
(93) on the inner side of the brackets.
(3/8"-16 x 1/2")
PIVOT ARM ADJUSTMENT:
There are three adjustment holes on the
at three different heights. The lowest hole will allow the least amount of inversion angle. The top hole will
allow the greatest amount of inversion angle.
CAUTION: 1.
Use the lowest holes in the
Inversion System
2.
Both
ARMS(91)
STEP 4
MAIN FRAME(92)
Attach the
PIVOT ARMS(91)
(43, 44)
.
PIVOT ARMS(91)
Secure the PIVOT ARMS(91) with the SECURING KNOBS
in position.
PIVOT ARMS(91)
PIVOT ARMS(91)
to different positions could cause damage to the machine, and injury to the user.
REAR FRAMES(2, 3)
onto the
into the slots on the
A
into the brackets located at each side of the
allowing you to position the
PIVOT ARMS(91)
must be adjusted to the same hole. Trying to adjust the
REAR FRAMES(2, 3)
7
until you become familiar with the
by sliding the slots in the ends of the two
and secure with the
B
C
MAIN FRAME
MAIN FRAME(92)
Elite
PIVOT
SHAFT CLIPS