ASSEMBLY INSTRUCTIONS
STEP 10
HEIGHT ADJUSTMENT BEAM(10)
Install the
MAIN FRAME(92)
on the
LOCKING KNOB
safety, thread the
WARNING:
Do not use the
to use the proper height setting can result in difficulty recovering from the decline position.
HEIGHT ADJUSTMENT
See
STEP 11
Insert the front ends of the
the back ends of the
and inserting the
(3/8"-16 x 3/4")
Elite Inversion System
HANDRAILS(5)
HANDRAILS(5)
with
MAIN FRAME(92)
into
HEIGHT ADJUSTMENT BEAM(10)
(36)
into back side of the
until you have verified your height setting. Failure
instructions on page 11.
onto the short tubes on
BOLTS(M8 x 50mm)(63)
10
SPRING PIN(35)
by pulling the
as shown. For added
MAIN FRAME(92).
REAR FRAMES(2, 3).
WASHERS(M8)(69).
and
Then attach