Table of Contents
Advertisement
OPERATIONAL INSTRUCTIONS
INVERSION ANGLE ADJUSTMENT
There are 11 adjustment holes in the
ADJUSTMENT BARS(85)
NYLON BED(37)
movement of the
PULL PINS(86)
by inserting the
adjustment holes.
The top holes will allow the least amount of inversion
angle. The lowest hole will allow the greatest amount of
inversion angle and the
go into the full inversion position.
CAUTION:
1.
Use the holes near the top in the
ADJUSTMENT BARS(85)
Elite Inversion System.
familiar with the
PULL PINS(86)
2.
Both
ANGLE ADJUSTMENT BARS(85).
hole in the
Trying to insert the
positions could cause damage to the machine, and
injury to the user.
HEEL HOLDER USE AND ADJUSTMENT
1.
Place your feet on the
HEEL HOLDERS(15)
HEIGHT ADJUSTMENT BEAM(10)
2.
The
grip and release your feet. Pull the
ankles are securely held between the
FOAM PADS(18).
3.
To release your feet or relax the grip, pull the
slightly and press the button on the end of the lever.
THE HANDRAILS
For added convenience, and safety, a set of
HANDRAILS
These
the upright position from any degree of inversion. If you wish to return to the upright position, and the bed
is moving too slowly, or not moving at all, simply grab the
the upright position.
allowing you restrict the
to different angles
into different
Elite Inversion System
until you become
must be inserted into the same
PULL PINS(86)
into different
FOOTREST(11)
FOAM PADS(18).
and
LEVER(23)
HANDRAILS
are located at both sides of the frame. The
ANGLE
will
ANGLE
with your ankles between the
LEVER(23)
includes a
toward you until your
HEEL HOLDERS(15)
LEVER(23)
toward you
has been added to the
HANDRAILS
12
Button
to
and
Elite Inversion System.
HANDRAILS
are to help you return to
and pull on them until you return to
Advertisement
Table of Contents
